T&T: KL Industries Boat tender 9.4

[Richard Tomkinson]

This boat is polyethylene. Is 3M5200 (which is polyethylene) recommended as an
adhesive for mounting up the backing pads for the davits?
Richard

  ----- Original Message -----
  From: Ross Lappin
  To: capnrich at wavecable.com ; trawler list
  Sent: Monday, June 01, 2009 2:16 PM
  Subject: RE: T&T: KL Industries Boat tender 9.4


  Richard

  Not that particular brand but I have thge Livingston 9 on Weaver davits.  I
purchased one with extra reinforced side panels molded into the gunnals -
gives it lots more strength for riding up on two points for extended periods.
That would be my only concern with the KL - check if they can stiffen one uip
for you.

  Ross

  >
  > Does anyone have experience mounting this dinghy using Weaver davits?
  > Richard
  > _______________________________________________
  >


-----------------------------------------------------------------------------
-



  No virus found in this incoming message.
  Checked by AVG - www.avg.com
  Version: 8.5.339 / Virus Database: 270.12.48/2148 - Release Date: 06/01/09
06:09:00