T&T: Xantrex MS2000

[AgajanianYS at aol.com]

Happy day-after to all...
 
I'm getting messages on my control panel for my MS2000 ,, When my  generator 
is under heavy load it reads "line voltage too high will invert  only"... 
Although it says "Will invert only", everything keeps on working.
 
.The panel shows 108 volts, 58 hertz and 16.5 amps going into the charger  
.This is a bit low, but not high at all. When I'm using the galley stove and the 
 hot water heater is on, I usually cut down the charger to not over load my  
ancient MDJE Onan.
 
Rather than start with the legendary Xantrex service, I thought I'd ask the  
list first and see if anyone had an opinion..
 
Thanks in advance
 
Sam Agajanian



**************It's only a deal if it's where you want to go. Find your travel 
deal here.      
(http://information.travel.aol.com/deals?ncid=aoltrv00050000000047)