T&T: snap fastener studs in fiberglass

[Tom Barnes]

Go Keith...... Haven't heard of this one. Sounds really neat. Thanks!

Tom B.

--- On Wed, 4/9/08, Keith <keith at anastasia3.com> wrote:

  From: Keith <keith at anastasia3.com>
  Subject: Re: T&T: snap fastener studs in fiberglass
  To: "Trawlers and Trawlering"
  <trawlers-and-trawlering at lists.samurai.com>
  Date: Wednesday, April 9, 2008, 9:08 AM

  Neat little trick in the West Systems epoxy book: Take a little piece of 
  sponge and soak it in epoxy. Stick it halfway through the hole and let it 
  cure, then cut off the excess on the outside. Redrill and use whatever 
  hardware you have.

  Keith
  _____
  Annoy the IRS: Fill out your tax form using binary
  ----- Original Message ----- 
  From: "Keith McGregor" <keith.kmcgregor at gmail.com>

  > Frank -
  >  You might be better served by using the next larger size stud.  Mind you,
  > I am talking about the screw that is larger in diameter.  This eliminates
  > the need for using Marinetex, which can be quite messy. 
  _______________________________________________
  http://lists.samurai.com/mailman/listinfo/trawlers-and-trawlering
  
  To unsubscribe or modify your subscription options (get password, change email
  address, etc) go to:
  http://lists.samurai.com/mailman/options/trawlers-and-trawlering
  
  Trawlers & Trawlering and T&T are trademarks of Water World
  Productions. Unauthorized use is prohibited.
Tired of spam? Yahoo! Mail has the best spam protection around
http://mail.yahoo.com