T&T: Backing material

[LA Licata]

Keith,

I would think no more than 3/8" but I also would have the backing  
plate extend at least 2 inches beyond the tip of the cleat, and the  
width be at least half as wide as the length....

I think this is overkill, but I am just that sort of boater....

Hate surprises....

Lee

On 27 Jun 2007, at 03:34, Keith wrote: Assuming stainless steel is  
used, what does the group think is a proper thickness to use? I would  
think fairly thick to make it stiff and spread the load over a large  
area. Keith

[demime 1.01d removed an attachment of type application/pkcs7-signature which had a name of smime.p7s]