T&T: Sliding door

[Jeff Barfett]

Bill,
I've searched for a number of years for a track that would work on the
sliding doors without luck. Do you have a source you can share?

Thanks,
Jeff on Southern Nights

Subject: Re: T&T: Slinding door

 I replaced the thirty-year old wheels, which had been milled flat, with
screen door wheels with bearings from Home Depot. A simple drill through the
bottom of the door was all that was required. Put a stainless steel track in
the wood sliding track with an inch cut off of either end so that the wheels
at the end of their roll drop off the track and, as a result, the door stays
in place under way. Did this two years ago and its working fine.
 
Bill French,
Satisfied Three
DeFever Passagemaker 40